Hull Geological Society

 

Home
Local Geology
Next Meeting

Geology field guides and walks

Barmston, East Yorkshire.

Disclaimer – details about parking and facilities may have changed since the author last visited these sites.

Note all sites are best visited on a falling tide. For some the tide is critical either to view the site or to avoid getting stranded. You are recommended to wear a hard hat when examining cliffs.

Summary -

Conservation status -

Parking – on street parking in the village or perhaps at the caravan site if you ask permission

Facilities – there are toilets at the bar on the caravan site

Access – after a cliff top walk there very low cliff to the north of the site and a slope to the south.

Beach – gravel and sand

Hazards – possible cliff falls

Safety and PPE – normal outdoor clothing and a hard hat if you want to have a close look at the cliffs

Geological highlights – post glacial lake deposits, glacial deposits.

 

The excursion -  Barmston. Coastal cliff sections between TA172579 and TA 169600.

The coastal cliffs at Barmston (figure 3) are low and undulating, reaching a maximum height of 10m OD. Due to their ‘soft’ nature erosion rates can be rapid and average some 2m per year. The most recent published research on the glacial sediments here, and more widely in Holderness, is that of Evans and Thomson (2010). They have proposed that the sediments represent a series of minor readvances of the North Sea Lobe, each of which tectonised pre-existing deposits to produce a subglacial glacitectonite facies together with subaqueous outwash sediments, forming ridges at the ice margin. They identified three major litho-facies associations (LFA1, LFA2 and LFA3) within these depositional systems and these are usually visible in the Barmston Cliffs.

Air photograph of Barmston cliff

Figure 3. Air photograph of much of the Barmston section. Approximately 2km in length. Note the increased erosion south of Barmston Road End and Barmston Drain and locally increased erosion where gravel and sand bodies, loaded into Skipsea Till, have been preferentially washed out of the cliff. [We thank Brian Kneller of the FQRG for obtaining this photograph and Neil McLachlan of the East Riding of Yorkshire Council for giving permission for its use.]

Skipsea Till diamicton makes up the lower parts of nearly all the cliff exposures with from about 1m to 6m visible. It is typically a matrix supported massive diamicton of dark greyish brown colour (Catt 2007) though subtle colour variations are seen. Stratified and laminated facies are also recorded and both ductile and brittle deformation structures can be seen, indicating stress from the north or northeast mirroring the regional clast fabrics. Attenuated lenses and rafts of grey and reddish brown silty/sandy clay can also be seen in the section possibly derived from Mesozoic bedrock lithologies to the north.

Of particular interest is the undulating upper surface of Skipsea Till (LFA1). Whilst reaching over 6m above beach level in some locations it is also seen just above the beach in others (figures 7 and 16). This feature has been interpreted as either an irregular surface due to meltout and slumping as a surge lobe decayed together with possible squeeze ridges (Eyles et al 1994, Evans et al. 1995) or possibly as subtle proglacial deformation produced by re-advance, possibly that of the Withernsea Till ice (Evans & Thomson 2010).

Though not mentioned in any detail by Evans and Thomson (2010) Skipsea Till (LFA1) displays a very conspicuous sub-vertical joint system along the Barmston Cliff section, and indeed at other sites on the Holderness Coast. Penny and Catt (1967) first recorded these features and interpreted them as conjugate sheer joints formed by stress from the northeast during a small re-advance to form the “Barmston Push Moraine” (figure 7). Recent measurement of the sub-vertical joints along this section in September 2012 (figures 8 and 9) failed to replicate the orientations obtained by Penny and Catt. The previously visible joints, commonly present throughout the entire exposed thickness of the diamicton, do not show any vertical displacement of diamicton stratification and are commonly seen within apparently  diapirically intruded diamicton ‘columns’. This, together with the loaded bodies of gravel and sand which commonly overlie the diamicton (figures 7, 11 and 13) suggest its upper part was saturated at deposition. These features combined suggest the joints formed ‘late’ and are the product of dewatering and compaction of the diamicton.

 Well jointed Skipsea Till

Figure 7. Well jointed Skipsea Till (LFA1, Dmm) at TA1730 5792 (the spade for scale is 1m long). Barmston south. Note the irregular loaded contact with overlying gravels and sands (LFA3).

 Skipsea Till joint orientation

Figure 8. Sub-vertical joint orientations measured in the Skipsea Till at TA 1730 5791, close to Catt and Penny’s 1967 “push moraine” site. N = 60. The orientation of Catt and Penny’s conjugate shear joints are shown in red for comparison with the FQRG data from September 2012.

joint orientation in Skipsea Till 

Figure 9. Sub-vertical joints measured along the Barmston section in the Skipsea Till from TA 1730 5791 to TA 1715 to 5881. N = 305.  The FQRG data is from September 2012. The orientation of Catt and Penny’s conjugate shear joints are shown for comparison.

 Deformation structures at the top of the Skipsea Till

Figure 11. Barmston central TA 1713 5883 (rucksack for scale). Deformation structures at the top of the Skipsea Till overlain by gravels and sands, with fine grained rhythmites high in the section.

 Barmston central

Figure 13. Barmston central TA 1705 5916 (rucksack for scale). Gravel pendant structures. Saturated till loaded by overlying sandy gravels.

At a few locations at Barmston south ‘inter-beds’ of gravelly sands can be seen between the Skipsea Till diamicton (LFA1) units (figure 10). The ‘upper till’ is typically weathered to a reddish brown colour. Evans and Thomson (2010) have interpreted such bodies as subglacial canals transporting meltwater and sediment to the ice front at times of high discharge ultimately to build ice front fan bodies. Whilst this seems a plausible explanation, Bateman et al.s’ (2011) investigation of a much larger body between Withernsea and Skipsea Tills at Dimlington suggest some possible proglacial sandar with overlying re-advance tills. Detailed investigation of each body is now warranted.

 Well jointed Skipsea Till

Figure 10. Barmston south, TA 1722 5820 (spade and geologist for scale). Well jointed Skipsea Till overlain by gravelly sand and a further diamicton unit. Is this subglacial channel fill or proglacial outwash overlain by a minor re-advance till?

In most of the available exposures LFA1 diamicton is overlain by small and large bodies of gravels and sands (LFA3 of Evans and Thomson 2010) (figures 7, 11 and 13). These range from large pods to smaller ‘pendant’ structures (figure 13). All appear to have been loaded into originally saturated, plastic, diamicton. LFA3 can be found both where the diamicton is low or high in the cliff and locally (as in figure 11) the deformation structures appear to be overturned in a consistent northward direction.

Along the Barmston central and northern sections LFA1 and LFA3 are typically overlain by a sequence which appears to ‘drape’ a pre-existing topography. The sequence coarsens upwards from sand/silt/clay rhythmites (LFA2b of Evans and Thomson 2010) (see figures 5, 12 and 16) into massive and de-watered sands, rippled sands (LFA2a) and finally into sandy and gravelly clinoforms (LFA2a and LFA3) marking progradation of subaqueous fan bodies within the glacilacustrine basins (figures 16, 17 and 18). At one site (figure 14) low angle thrusts disrupt bedding within the LFA2b rhythmites and may be rooted in deformation structures in the underlying diamicton. It is as yet unclear if this deformation is due to loading and compaction during deposition of the units or possibly gentle proglacial deformation? Occasionally ice wedge casts can be seen penetrating downwards into this sequence from near the present surface indicating subsequent permafrost development.

Millimetre scale rhythmites 

Figure 12. Barmston Central TA 1715 5870 (pound coin for scale). Millimetre scale rhythmites with a small dropstone. Bed LFA2b of Evans and Thomson (2010).

 Barmston Road End.

Figure 16. Barmston Road End. TA 1710 5935 (walking pole for scale). Compare with figure 5. The sequence from the base is: Skipsea Till is exposed below the beach. Overall coarsening upwards sequence within glacilactustrine basin fill. Clay/silt rhythmites low in the section contain small pebble rich horizons and isolated drop stones. Overlain by gravelly sands with conspicuous load structures. These are overlain by better bedded sands to the cliff top.

rippled sands at Barmston  

Figure 17. Barmston North TA 1708 5940 (spade handle for scale). Rippled sands in the central part of the coarsening upwards glacilucustrine sequence.

  Rhythmites and sands at Barmston

Figure 18. Barmston north TA 1705 5968 (section about 5 m high).  Rhythmites and sands overlain by low angle clinoforms. Subaqueous outwash fan terminating the basin fill.

 The LFS2b rhythmites were studied by Rushworth (1998) at a site close to that shown in figure 16, now lost to coastal erosion. He counted 395 laminae, suggested that they were true varves and that the proglacial lake persisted here for more than 350 years. In June of this year [2012] as yet undescribed trace fossils were discovered on bedding planes within these sediments (cf. Gibbard and Stuart 1974) and may provide useful plaeoecological information with further study.

Barmston Lake deposits 

Further north there is a low cliff and the land behind it is very low lying. This is the site of an ancient post-glacial lake or mere. Here you can see above the boulder  clay grey freshwater silts overlain by peat and then a modern soil. Arthur Speed (2021) found freshwater snail remains in the lake deposits.

References -

Bateman M D, P C Buckland, M A Whyte, R A Ashurst, C Boulter & E Panagiotakopolou 2011. Re-evaluation of the Last Glacial Maximum typesite at Dimlington UK. Boreas 40, 573-584.

Evans D J A & S A Thomson 2010. Glacial sediments and landforms of Holderness, eastern England: a glacial depositional model for the North Sea Lobe of the British-Irish ice sheet. Earth Science Reviews 101, 147-189.

Eyles N, A M McCabe & D Q Bowen 1994. The stratigraphic and sedimentological significance of Late Devensian ice sheet surging in Holderness, Yorkshire, UK. Quaternary Science Reviews 13, 727-759.

Gibbard P L & A J Stuart 1974. Trace fossils from proglacial lake sediments. Boreas 3, 69-74.

Penny L F & J A Catt 1967. Stone orientation and other structural features of tills in East Yorkshire. Geological Magazine 104, 344-360.

Rushworth G 1998. Rhythmites from Barmston, East Yorkshire. Quaternary Newsletter 86, 17-21.

Speed A 2021. An Ancient Mere at Barmston on the Holderness Coast – The Snail’s Tale Humberside Geologist number 16.

 

Copyright - Mike Horne and Hull Geological Society 2026

Based on a field guide by the Flamborough Quaternary Research Group of the Hull Geological Society: Colin Clark, Rodger Connell, Derek Gobbett, Dennis Haughey, Ian Heppenstall, Mike Horne, Stuart Jones, Brian Kneller, Chris Leach, Paul Richards and Rod Towse. First published in 2012 and partly updated in 2026.

Registered Educational Charity No. 229147

Home